The Skills Guide for Facility Managers details 10 must-have traits for those new to the industry
This peer-to-peer networking session will cover best practices for working with young facility professionals
One of the most common window problems is moisture penetration and related damage to interior finishes. Moisture accumulation can also lead to mold development and subsequent health risks. For these reasons, moisture ingress is one of the most litigious problems related to window systems.
With barrier-type systems, problems associated with moisture ingress are typically related to ineffective exterior seals, either from improper original installation or aging of the materials. For drainage systems, interior water penetration can occur through poorly functioning internal system seals or water overflowing horizontal members, such as sills. Internal drainage systems should include watertight joints and seals, end caps at terminations, and drainage holes to allow water to exit the system. Sill members of drainage systems also should be designed to accommodate anticipated water height within the system, which is based on design wind pressures. Defects in any one of these components or seals can result in interior leakage.
Other problems associated with windows are air leakage and condensation. These problems, particularly cold drafts, can affect occupant comfort and can result in interior moisture damage. Air leakage can occur as a result of high winds or building pressurization problems and is typically due to poor internal seals or gaskets. As gaskets age and are subjected to movement, increased air infiltration typically occurs.
A typical condensation problem is evident if there is moisture at the interior surface of the glass unit or sill framing members independent of rain. Condensation occurs when the interior surface temperature of the window assembly falls below the dew point of the adjacent air. The potential for interior condensation increases in buildings in cold climates particularly if the interior is humidified during cold weather.
Condensation on metal frames can also result from poor placement of the window within the exterior wall where thermal bridging can occur. For example, where the window is installed outside of the wall insulation system for the adjacent cladding, cooling of interior portions of the window frame can occur during cold exterior temperatures.
Other potential problems with window performance include failure of structural elements or connections, glass failures and breakage, fogging of insulated glass units, and failure of coatings.
When deciding whether window systems should be repaired or replaced, consider the following questions to understand the condition of the existing system.
One of the first steps in answering these questions is to determine the nature and extent of existing problems. Perform surveys of the interior and exterior of the systems to determine locations of water-related damage and potential conditions on the exterior that may cause such damage. Check with staff to identify locations, extent and frequency of occurrence of observed water leakage. This survey can help determine if the problems are primarily concentrated at specific locations or are systemic to the entire building.
To understand fully how the window system performs under various conditions, field testing is often recommended. This is particularly important when investigating the source of water leakage or air infiltration problems. Testing can be performed in accordance with standards published by ASTM International and the American Architectural Manufacturers Association to evaluate the performance of an installed window.
Performance testing of windows, as well as of the surrounding wall, also provides baseline data that can be used in the future when testing is performed to evaluate trial repairs or replacement approaches. In conjunction with field testing, it is beneficial to create inspection openings through interior finishes to monitor for leakage during testing and to verify the condition of anchorage. When necessary, various components of the window system can be disassembled to observe internal conditions. This effort, combined with determining the interior air conditions and surrounding wall interface construction, can be critical when investigating condensation problems.
Avoiding Water Penetration in Windows
Moisture, Condensation and Mold: Typical Window Problems