On Feb. 17, our virtual networking session will cover new employee onboarding and retention best practices
Staffing, supply chain issues and workplace changes are the challenges facing FMs
When tunable LEDs are combined with daylighting, they do help meet new energy efficiency standards, such as the American National Standards Institute (ANSI), ASHRAE and Illuminating Engineering Society (IES) Standard 90.1-2016, “Energy Standards for Buildings Except Low-Rise Residential Buildings.” Standard 90.1 is the benchmark for commercial building energy codes in the United States.
In the 2016 edition, interior lighting power density limits were revised primarily because of the increased efficacy of LEDS. Building area lighting power density limits were reduced as much as 13 percent, depending on specific building type, with an overall average reduction of 12 percent from 90.1-2013 levels. Modified requirements for exterior lighting densities also are presented. Both reflect new lighting levels in the IES Lighting Handbook.
Currently being developed, Standard 90.1-2019 is expected to include additional LED technology advances, further reducing space type and building lighting power density values.
Lighting controls in Standard 90.1-2016 also have modified requirements for additional controls in some space types and options for others, focusing on easier application of advanced controls.
LEDs and advanced controls actually are part of contemporary daylighting design strategies. “Even in 100 percent daylight prototypes, we still have to design indoor luminance,” points out Jackson.
Advanced controls help ensure that LEDs are off when and where daylight is sufficient to light the space. However, daylight can create a bright perimeter space that makes a less bright interior space appear and feel darker. In such situations, lighting designers balance the light, so the illumination is similar across the floorplate, Jackson says.
“At this point, the new LEDs come into play,” Jackson says. “By allowing various color temperature ranges, they can bump up the interior zone, while staying off along the perimeter.”
Guglielmetti agrees that combining the assets of daylighting with new LEDs and advanced controls is best practice in architectural lighting design. “Natural daylighting and new LEDs perfectly complement each other,” he says.
Guglielmetti also notes LEDs offer buildings seeking net-zero status additional benefits. In addition to using very few watts, LEDs operate on direct current, which means they can operate on power generated off the grid. For example, if a building has solar panels on the roof, the electric power generated by the rooftop photovoltaics can directly power LED lighting without using an alternating current converter, Guglielmetti explains. This means virtually all the off-grid generated power is actually consumed, with no conversion losses.
LEDs also can be connected via Ethernet cable, according to Guglielmetti. And, with their advanced controls, they can be independently remotely controlled. “Older lighting is zoned and circuited,” Guglielmetti says. “LEDs are much more easily controlled, allowing building occupants to make decisions on the best lighting for their space.”
“Good lighting designers never rule out a performer,” says Guglielmetti. “That’s backward thinking. Using modern LEDS combined with natural daylighting allows us to provide architectural lighting design that truly benefits each building occupant.”
Rita Tatum, a contributing editor for Building Operating Management, has more than 30 years of experience covering facility design and technology.
Email comments and questions to email@example.com.
Daylighting and LEDs Team Up to Meet Energy Efficiency Standards